Cycle-Tek air shifter for the GenII

[Tybalt]

Check out Cycle-tek.com or contact matt@cycle-tek.com for the new kit for the 2008 hayabusa. Very nice kit and Matt is a great guy:thumbs up:

NEW RELEASE! 2008 SUZUKI HAYABUSA Co2 AIR SHIFTER SYSTEM!
Due to limited space for the traditional 9oz Co2 cylinder, two 3.5oz cylinders are standard with the system. Each full 3.5oz Co2 cylinder is good for around 65 shifts, and they fit perfectly on the right side of the trunk. $365 plus shipping and paypal fees

[EXTREMEFUN1300]

Thanks, Chief!

That is correct, the Suzuki's redesigned undertail and trunk area leaves limited space for the traditional 9oz Co2 cylinder run on the 99-07 Busa Co2 shifter systems, so the smaller 3.5oz cylinders must be used. They're good for around 65 shifts, two bottles included standard with my '08 system. If you're adventurous and want to cut some plastic in the back of the tail section near the tail light, you can fit a 9oz cylinder, though the on/off valve knob must be orientated 180deg (pointing down), which makes it a little more difficult to turn on and off.

I also offer many other high pressure controls for boost controller over ride pressure, any misc air fitting you could imagine and spare parts for your shifter system, mine or otherwise.

Thanks again, Chief, for giving me the opportunity to join the site and try to help out our Busa brothers and sisters!

Matt Thomas
matt@cycle-tek.com


www.cycle-tek.com (http://www.cycle-tek.com)

[smithabusa]

Thanks, Chief!

That is correct, the Suzuki's redesigned undertail and trunk area leaves limited space for the traditional 9oz Co2 cylinder run on the 99-07 Busa Co2 shifter systems, so the smaller 3.5oz cylinders must be used. They're good for around 65 shifts, two bottles included standard with my '08 system. If you're adventurous and want to cut some plastic in the back of the tail section near the tail light, you can fit a 9oz cylinder, though the on/off valve knob must be orientated 180deg (pointing down), which makes it a little more difficult to turn on and off.

I also offer many other high pressure controls for boost controller over ride pressure, any misc air fitting you could imagine and spare parts for your shifter system, mine or otherwise.

Thanks again, Chief, for giving me the opportunity to join the site and try to help out our Busa brothers and sisters!

Matt Thomas
matt@cycle-tek.com


www.cycle-tek.com (http://www.cycle-tek.com)


Good stuff Matt :banana:

[Fast08]

Hey guys I bought two of Matts kits for the 08 Busa's and all I can say is it is a very nice kit! We installed the first kit on my Buddys 08 last weekend with no issues at all. And for using the 9 oz bottle you do not have to do any cutting on the floor by the tail light the bottle will slide in there just fine. you do have to notch the Hump floor, takes less the 15 minutes with small grinder or Dremel tool.

[poboybusa]

has anyone taken pics ? or how about installation instructions ??? :confused:

[Tybalt]

has anyone taken pics ? or how about installation instructions ??? :confused:
I believe this is the 08 GenII set-up?

[poboybusa]

I believe this is the 08 GenII set-up?
thanks Warchief , the trunk looks a little busy. :cheers: